在网上看到一位大虾的关于redhat 7.2下面配置VPN客户端的文章如下:
Password:
This is the password or CHAP secret for the account specified. The
password will not be echoed.
Password: ;在这里敲入密码,密码不回显
回到主选单
Adding secret pptp PPTP *****
1.) List CHAP secrets
2.) Add a New CHAP secret
3.) Delete a CHAP secret
4.) List PPTP Tunnels
5.) Add a NEW PPTP Tunnel
6.) Delete a PPTP Tunnel
7.) Configure resolv.conf
8.) Select a default tunnel
9.) Quit
?: ;此时建立一个新的PPTP Tunnel,选择5
Add a NEW PPTP Tunnel.
1.) Other
Which configuration would you like to use?:1 ;只有这一个,选1
Tunnel Name: test ;给连接起名字test
Server IP: 10.0.0.227 ;vpn服务器的ip
What route(s) would you like to add when the tunnel comes up?
This is usually a route to your internal network behind the PPTP server.
You can use TUNNEL_DEV and DEF_GW as in /etc/pptp.d/ config file
TUNNEL_DEV is replaced by the device of the tunnel interface.
DEF_GW is replaced by the existing default gateway.
The syntax to use is the same as the route(8) command.
Enter a blank line to stop.
route: TUNNEL_DEV ;用提示的输入
route: ;一个就够了,回车结束
Local Name and Remote Name should match a configured CHAP secret.
Local Name is probably your NT domain\username.
NOTE: Any backslashes (\) must be doubled (\\).
Local Name: pptp
Remote Name [PPTP]:
Adding test - 10.0.0.227 - pptp - PPTP
Added tunnel test
1.) List CHAP secrets
2.) Add a New CHAP secret
3.) Delete a CHAP secret
4.) List PPTP Tunnels
5.) Add a NEW PPTP Tunnel
6.) Delete a PPTP Tunnel
7.) Configure resolv.conf
8.) Select a default tunnel
9.) Quit
?:9
退出后再进入程序
# ./pptp-command
1.) start
2.) stop
3